JVC TV 20240 - Manual (Page 24)

23 T R O U B L E S H O O T I N G / I T R
TIMER RECORDING
TROUBLESHOOTING
The following are some common
problems/issues that may arise while
using Timer Recording.
REC lamp starts flashing when you
press T
IMER
on the remote control.
No cassette is loaded into VCR.
Insert a cassette into VCR and
continue.
Cassette loaded has its recording tab
removed.
Insert a recordable cassette, or cover
the missing tab hole with two layers of
tape.
The following message appears
when attempting to eject tape or
operate VCR:
Press the T IMER button and set Timer
Mode to Off. Try operating VCR again.
To stop taping once automatic
recording has begun.
Press the T IMER button, then the S TOP
button.
INSTANT TIMER
RECORDING (ITR)
Instant Timer Recording allows you to set
the VCR timer after the videotaping of a
program has begun. The ITR timer can
be programmed to stop recording up to
four hours after it has begun.
To use the ITR timer, the VCR must
already be recording. Press the R
EC /I TR
button on the front panel of the VCR
(Note: This function cannot be accessed
with the remote control)
R EC /I TR
The following display will appear on the
screen:
The timer above is set to stop recording in
30 minutes.
Press the ITR button again to increase
the amount of time on the ITR timer. Each
press increases the amount by 30
minutes. The ITR timer can be set from a
minimum of thirty minutes "ITR 0:30" to a
maximum of four hours "ITR 4:00" When
the time allotted to the ITR expires, the
recording automatically shuts off.
Note: To cancel the ITR timer, press the
R EC /I TR button until the on-screen display
disappears.
Note: To stop recording before the
allotted time expires, press the S TOP
button.
VCR TIMER IS ON. PUSH
TIMER BUTTON TO RELEASE.
ITR 0:30
COUNT 0:00:01
REC 22