JVC TV 20240 - Manual (Page 14)

CHANNEL GUARD - LOCK
To CHANNEL SUMMARY
To operate
C HANNEL +/- to select the channel
To the Lock column
The access code zero (0) to lock
or unlock that channel
E XIT when finished
Note: When viewing, once the Channel
Guard for a specific channel has been
unlocked, that channel will remain
unlocked until power to the television is
turned off. To reactivate Channel Guard,
turn the power off and then on again.
CHANNEL GUARD MESSAGE:
This message appears when a viewer
attempts to watch a guarded channel:
To watch a channel you have locked, enter
the lock code using the 10 key pad. An
explanation of how to set the lock code
appears in the next column on this page.
If the wrong lock code is entered, this
message will flash on the screen:
1 3 I N I T I A L S E T U P
I N VALID LOCK CODE !
Continued …
PLEASE ENTER LOCK CODE BY
10 KEY PAD TO UNLOCK IT.
NO. – – – –
SET LOCK CODE
The Lock Code locks and unlocks
Channel Guard settings. Write this four
digit number down and keep it safe
from potential viewers!
P ress any M E N U b u t t o n
To SET LOCK CODE
To operate
The padlock icon appears
Z ERO (the access code is zero )
To choose the number
To move to the next place
Continue to follow these directions for
all four numbers
To FINISH
To save settings and exit
E XIT when finished
Note: If you forget your Lock Code
you can check your code by going to
the setup screen of the Set Lock Code
function.
Note: After a power interruption of
more than 90 seconds you must reset
the lock code.
LOCK CODE 0 0 0 0
F I N IS H
CH NO. SCAN CH NO. SCAN
0 1 06
√
0 2
√
07
0 3
√
08
0 4
√
09
√
0 5
√
10
√