JVC TV 20240 - Manual (Page 13)

CHANNEL SUMMARY
You can add or delete channels from
channel scanning. You can also lock
out any “unauthorized” viewers from
one or up to all 181 channels.
Press any M ENU Button
To CHANNEL SUMMARY
To operate
Note: Noise Muting will not work while
you are in the Channel Summary menu .
SCAN
You can manually set channels to scan
that were too weak to be picked up
during Auto Tuner Setup. Conversely, if a
channel was too weak to receive a good
p i c t u re but was picked up anyway, delete
it by removing the
√
. (If you have not
p e rf o rmed the Auto Tuner Setup
described in the previous column, please
do so now.)
C H A N N E L - / + to select the channel
To the SCAN column
To add or delete from scan
E XIT when finished
Note: Channels set to scan will be
marked with an
√
.
Note: Some cable systems experience
interference from radio frequencies on
Cable Channel 95. If you like, you can
delete this channel f rom scanning by
removing the
√
I N I T I A L S E T U P 1 2
AUTO TUNER SETUP
During Auto Tuner Setup, the TV w i l l
automatically scan through all available
channels and memorize the active ones
so that when you scan, you do not pick
up weak or noisy channels.
Press any M ENU button
To AUTO TUNER SETUP
To operate
To choose CABLE or AIR
To move to START
To start Auto Tuner Setup
The Programming takes approximately
1 to 2 minutes
Note: Noise Muting will not work while
Auto Tuner Setup is working.
NOW
PROGRAMMING!
48
TUNER MODE : CABLE AIR
START
PROGRAMMING OVER!
Continued next page ...
NOTES:
During Initial Setup,
the TV will be
programmed to
only receive active
channels. Once the
channels are
activated by the
Auto Tuner Setup
they will be includ-
ed in Scan.
Some weak
channels may be
included or omitted
during this
procedure. You can
add or delete any
channels from
scanning in the
Channel Summary.
CH NO. SCAN CH NO. SCAN
0 1 06
√
0 2
√
07
0 3
√
08
0 4
√
09
√
0 5
√
10
√