JVC KD-ADV6580 - Manual (Page 18)

18
ENGLISH
Operations using the on-screen bar
(DVD/DVD-VR/MPEG Video/VCD)
These operations are possible on the monitor using the
remote controller.
1
Show the on-screen bar (see page 19).
2
Select an item.
3
Make a selection.
If pop-up menu appears...
• To cancel pop-up menu, press RETURN.
• For entering time/numbers, see the following.
Entering time/numbers
Press % / fi to change the number, then press @ / # to
move to the next entry.
• Each time you press
%
/
fi
, the number increases/
decreases by one value.
• After entering the numbers, press ENT (enter).
• It is not required to enter the zero and tailing zeros
(the last two digits in the example below).
Ex.: Time search
DVD: _:_ _:_ _ (Ex.: 1:02:00)
Press
% once, then # twice to go to the third entry, %
twice, then press ENT (enter).
Removing the on-screen bar
(twice)
• For MPEG Video/MP3/WMA/WAV, track is searched
within the same folder.
• For DVD-VR, program/playlist search is possible
during Original program playback (PG)/Playlist
playback (PL).
• To erase a misentry, press CLR (clear) while holding
SHIFT.
• To return to the previous screen, press RETURN.
Using menu driven features... (DVD-Video/
DVD-VR)
1 Press TOP MENU/DVD MENU to enter the menu
screen.
2 Press % / fi / @ / # to select an item you want to
start play.
3 Press ENT (enter) to confirm.
Canceling the PBC playback... (VCD)
1 During stop, press DIRECT while holding SHIFT.
2 Hold SHIFT, then press the number buttons (0 – 9)
to enter the desired number.
3 Press ENT (enter) to confirm.
• To resume PBC, press TOP MENU/DVD MENU.
EN18-27_KD-ADV6580[J]1.indd 18 EN18-27_KD-ADV6580[J]1.indd 18 1/30/09 2:08:41 PM 1/30/09 2:08:41 PM