Jaguar XK JJM 18 02 30 701 - Manual (Page 68)

77
Lighting
R
CHANGING A BULB
It is important that only the Jaguar
specified bulbs are used when renewing
bulbs.
The message centre will display a
message indicating which bulb requires
to be replaced.
Before renewing bulbs, switch off the
ignition system and light switches.
To change the bulbs within the headlamp
and taillamp, the complete units require to
be removed from the vehicle.
Note: In most countries it is illegal to use
a vehicle with a defective exterior lamp
bulb.
Headlight unit
!
WARNING:
• Replacement or maintenance of
Xenon lights should be carried out
only by a Jaguar Dealer.
• Used Xenon lamp units contain
mercury which is hazardous and
can be injurious to health.
• Bi-Xenon lamp units operate at a
high temperature. If they have
recently been in use, allow
sufficient time for them to cool
down before touching them.
• The Xenon system generates up to
28,000 volts and contact with this
voltage could lead to a fatality.
Ensure that headlamps are
switched off before working on the
system.
Caution: Seek advice about proper
disposal of Bi-Xenon lamp units from
your Jaguar Dealer or your local
authority.
1. Side marker (bulb type WY5W).
2. Direction indicator (bulb type, front
3457AK, rear PY21Silver Vision).
3. Low and high beam projector unit
(bulb type D1S35W).
4. Sidelamp (bulb type W5W).
5. Cornering lamp (bulb type H8).
JAG0145G
2 1 3 4 5