JVC PU30425 - Manual (Page 31)

31
ENTER PROGRAMME STOP
TIME
4
Press STOP +/– to enter the time you want recording to
stop.
● If you are using the Illumi-Guide feature, the following
buttons remain lit: START +/–, STOP +/–, DATE +/–,
and TV PROG +/–.
ENTER PROGRAMME DATE
5
Press DATE +/–. (The current date appears on screen.
The date you enter appears in its place.)
● If you are using the Illumi-Guide feature, the following
buttons remain lit: START +/–, STOP +/–, DATE +/–,
and TV PROG +/–.
ENTER PRESET POSITION
6
Press TV PROG. +/–.
● If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: START +/–, STOP
+/–, DATE +/–, and TV PROG +/–.
SET TAPE SPEED
7
Press SP/LP to set the tape speed.
RETURN TO NORMAL
SCREEN
8
After confirming all information is correct, press OK
and the normal screen appears.
● Repeat steps 1 – 8 for each additional programme.
ENGAGE RECORDER’S
TIMER MODE
9
Press TIMER.
To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 8, press WEEKLY (NUMBER
key “9”) for weekly serials or DAILY (NUMBER key “8”) for
daily serials (Monday – Friday).
9
6
PROGRAM 1
START STOP
21 : 00 22 : 00
SP ON
DATE TV PROG
25. 12 1
BBC1
[+ –] : SET = : OK
SP
M D
6
q
1 2
4 5
3
6
8
0
7 9
2
1
3 OK
WEEKLY
TIMER
DAILY
TV PROG.
SP/LP
SP/LP
7
7
8
TIMER
4
5
STOP+/–
DATE+/–
: PDC
NOTES:
● For safety, your recorder disables all other functions while in
the Timer mode. If you want to use the recorder but its Timer
mode is engaged, press TIMER and all other functions are
operable. To re-engage the timer, press TIMER.
● You can programme this recorder to timer-record as many as
8 programmes. If you try to programme the recorder to record
a ninth, "PROGRAM FULL" appears on screen and "FULL"
appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes (
੬
pg. 32).
● To timer-record a satellite broadcast through a satellite
receiver connected to the AV2 IN connector on the back of
the recorder, in step 6 above, set "TV PROG" to "AUX2" by
pressing TV PROG. +/–. Before the selected programme
begins, select the appropriate channel on the satellite
receiver, then set the receiver's timer. If your satellite receiver
doesn't have a timer, leave the unit's power switched on.
IMPORTANT
If you’re not receiving PDC (Programme Delivery
Control), press
: PDC (NUMBER key “7”) to set
to "OFF" (
੬
pg. 33).