JVC PU30425 - Manual (Page 5)

5
AV2 IN
RF OUT
PAUSE/
R.A.EDIT
RF OUT
ON–TEST–OFF
32
40
ANT. IN
AV1 IN/OUT
R L
AUDIO OUT
RF output channel
adjustment screw
Back of Recorder
TV Aerial Cable
RF OUT switch
Tune The TV To Your Video
Recorder
SET TV PRESET
3
Set your TV to the video preset (UHF channel 36). Two
white bars appear on screen vertically.
● Tune the TV until the bars are as clear as they can be.
● Your TV should be set to the preset designated for use
with a video recorder, or to a spare preset if there is
not a specified video preset on your TV.
RESET OUTPUT MODE
4
Return the RF OUT switch to ON.
NOTE:
If some interference noise is continually seen on the screen,
consult your JVC dealer.
The video recorder sends picture and sound signals via the RF
connecting cable to your TV on UHF channel 36.
* If you have connected the video recorder to your TV via both
the provided RF cable and 21-pin SCART cable, you can
ignore the rest of the following steps.
TURN ON THE RECORDER
1
Press OPERATE.
SELECT OUTPUT MODE
2
Set the RF OUT switch on the back of the recorder to
TEST.