Connecting the power supply, Important – Jensen BT360 User Manual
Page 7
Advertising
Bluetooth Car Kit User Manual
Connecting the power supply
The following illustration demonstrates how to connect the Car Kit’s
power cables to the vehicle’s electrical system.
Red cable
To battery + 12/24V
Blue cable
To ignition
Black cable
GND
Power cables
Yellow cable
To car radio
mute (NPN 300mA)
Important!
The Blue cable must be connected to the +12/24-volt switched
ignition to enable the Car Kit to go into standby mode.
Do not connect the Blue cable to the +12/24-volt constant
connection. Doing so may discharge the battery of the vehicle and
prevent the Car Kit from being reset.
3
Advertising