John Lewis JLBIGH601 - Manual (Page 5)

5
WHEN THE HOB IS FIRST INSTALLED WHEN THE HOB IS FIRST INSTALLED WHEN THE HOB IS FIRST INSTALLED WHEN THE HOB IS FIRST INSTALLED WHEN THE HOB IS FIRST INSTALLED
Once the hob has been installed, it is important to
remove any protective materials, which were put on
in the factory.
Installation Installation Installation Installation Installation
IMPORTANT IMPORTANT IMPORTANT IMPORTANT IMPORTANT::::: This hob must be installed according
to the instruction supplied, and by qualified and qualified and qualified and qualified and qualified and
competent personnel competent personnel competent personnel competent personnel competent personnel to the relevant National
Standards.
Any gas installation must be carried out by a registered
CORGI installer.
The manufacturer will not accept liability, should the
above instructions or any of the other safety
instructions incorporated in this book be ignored.
On the end of the shaft, which includes the G 1/2" threaded
elbow, adjustment is fixed so that the washer is fitted between
the components as shown in the diagram. Screw the parts
together without using excessive force.
Gas Connection Gas Connection Gas Connection Gas Connection Gas Connection
Connection to the gas supply should be with either rigid or
semi-rigid pipe, i.e. steel or copper.
The connection should be suitable for connecting to R 1/2‰
(1/2 BSP male thread). When the final connection has been
made, it is essential that a thorough leak test is carried out
on the hob and installation.
Ensure that the main connection pipe does not exert any
strain on the hob.
A ) A ) A ) A ) A ) End of shaft with nut
B )
B ) B ) B ) B ) Washer
C)
C) C) C) C) Elbow
It is important to install the elbow correctly, with the
shoulder on the end of the thread, fitted to the hob
connecting pipe.
Failure to ensure the correct assembly will cause
leakage of gas.
FO 0814
FO 0264