JVC CA-MXJ206 - Manual (Page 28)

– 25 –
English
STANDBY
POWER
– PRESET +
SET
CLOCK/TIMER
CANCEL
DEMO
SET
4
Set the on-time you want the unit
to turn on.
1) Press
4 or ¢ to set the hour, then
press SET.
2) Press 4 or ¢ to set the minute,
then press SET.
“OFF TIME” appears for 2 seconds, then
the unit enters off-time setting mode.
5
Set the off-time you want the unit
to turn off (on standby).
1) Press 4 or ¢ to set the hour, then
press SET.
2) Press
4 or ¢ to set the minute,
then press SET.
The unit enters preset station selecting
mode.
6
Select the preset station.
1) Press 4 or ¢ to select the band
(“TUNER FM” or “TUNER AM”), then
press SET.
2) Press 4 or ¢ to select a preset
channel number, then press SET.
The REC indicator stops flashing and
remains lit. The settings you have done are
shown on the display in sequence.
7
Press POWER to turn off the unit
(on standby) if necessary.
If you want to listen to another source while
recording.
Press REC START/STOP to stop recording. Without stopping it, you
cannot change the source.
To turn on or off Recording Timer after its setting is
done
1 Press CLOCK/TIMER repeatedly until
“REC” appears on the display.
2 To turn off the Recording Timer, press
CANCEL (on the unit only).
The REC indicator goes off and “OFF” appears
on the display.
The Recording Timer is canceled, but the setting
for the Recording Timer remains in memory.
To turn on the Recording Timer, press SET.
The REC indicator lights up on the display. The
settings you have done are shown on the display
in sequence for your confirmation.
– PRESET +
SET
– PRESET +
SET
TIMER
2
On the remote control:
1
Put a recordable cassette into deck B.
2
Press SHIFT.
3
Press TIMER until “REC” appears
on the display.
The REC indicator also starts flashing on the display.
• Each time you press the button, the timer setting mode
changes as follows:
DAILY = ON TIME = REC = ON TIME =
Clock setting (See page 11.)
= Canceled
4
Press TIMER again.
“ON TIME” appears for 2 seconds, then the
unit enters on-time setting mode.
REC
ST
REC SOUND MODE
REC
ST
REC SOUND MODE
SHIFT
5
Set the on-time you want the unit
to turn on.
1) Press SELECT – or SELECT + to set
the hour, then press SET.
2) Press SELECT – or SELECT + to set
the minute, then press SET.
“OFF TIME” appears for 2 seconds, then
the unit enters off-time setting mode.
6
Set the off-time you want the unit to
turn off (on standby).
1) Press SELECT – or SELECT + to set
the hour, then press SET.
2) Press SELECT – or SELECT + to set
the minute, then press SET.
The unit enters source selecting mode.
REC
ST
REC SOUND MODE
TIMER
2
– SELECT +
4 5
SET
8
– SELECT +
4 5
SET
8
MX-J300/206/200[C] 20-28 EN 00.4.10, 2:11 PM 25