JAI AT-140GE - Manual (Page 10)

AT-140GE
- 8 -
4. Locations and Functions
4.1. Locations and functions
1. Lens mount Lens mount of C-mount type. *1)
2. CCD sensor 1/2 inch CCD
3. RJ-45 connector GigE Vision interface with thumb screws
4. 12-pin connector DC+12V, Trigger IN and EEN out
5. D-sub 9-pin connector LVDS IN and TTL IN and OUT
6. LED Power and trigger indications
7. LINK Indication for Network connection
8. ACT Indication for GigE communication
9.Holes for RJ-45 thumbscrews Vertical type and horizontal type (*2)
10.Mounting holes M3, max length 5mm (*3)
*1) Note: Applicable C-mount lens should be designed for 3-CCD cameras. Rear protrusion on
C-mount lens must be less than 4mm.
Be advised: when using a lens with the iris diaphragm fully open, vignetting on corners
may occur.
*2) Note: When an RJ-45 cable with thumb screws is connected to the camera, please do not
excessively tighten screws by using a driver. The RJ-45 receptacle on the camera might
be damaged. For security, the strength to tighten screws is less than 0.147 Newton
meter (Nm). Tightening by hand is sufficient in order to achieve this.
*3) Note: The tripod adapter plate MP-41 can be used.
Fig. 1. Locations