JAI AT-140GE - Manual (Page 56)

AT-140GE
- 54 -
Specifications AT-140GE
Functions controlled via GigE
Vision Interface Shutter, gain, black Level, trigger mode, readout mode,
GPIO setup, ROI (GenICam mandatory functions)
GigE Vision Streaming Control
Packet size, delayed (frame) readout, inter-packet delay
Jumbo frame can be set at max. 16K (16020), default packet size is 1476 bytes.
Operating temperature -5  C to +45  C.
Humidity 20 - 80% non-condensing
Storage temp./humidity -25  C to 60  C./20% - 80% non-condensing
Vibration 3 G (15 Hz – 200 Hz in XYZ)
Shock 50 G
Regulations CE (EN 61000-6-2, EN 61000-6-3), FCC part 15 class B, RoHS
Power
10.8V to 26.4V DC. 0.61 A (Typical , Full frame ,12V input)
0.68 A (Typical ,1/8 partial, +12V input)
Lens mount
C-mount (Rear protrusion on C mount must be less than 4mm)
The lens used should be designed for 3CCD cameras.
Flange back 17.526mm, Tolerance +0 to –0.05mm
Optical axis Center  0.1mm
Dimensions 55 x 55 x 98.3 mm (HxWxD)
Weight 320g
Note: 1) Partial scan and vertical binning can not be used at the same time. Partial scan has priority.
2) Above specifications are subject to change without notice
3) Specifications are valid after a 30 min. warm up period.