JVC CA-NXHD10R - Manual (Page 30)

– 25 –
Adjusting the Input Level
If the sound from the component connected to the LINE IN
jacks is too loud or is not loud enough when changing the
source to the external component (without adjusting the
volume level), you can change the input level through the
LINE IN jacks.
On the unit ONLY:
1
When the source is “LINE*,” press and hold
REC MODE.
* If you have changed the source name of the external
component, the currently selected source name will appear
(see page 26).
2
Press SELECT ¢ or SELECT 4 to select an
appropriate input level.
• Each time you press the button, the input level
alternates between “LEVEL 1” and “LEVEL 2.”
LEVEL 1: Select this when the sound is not loud
enough.
LEVEL 2: Select this when the sound is too loud.
3
Press SET to finish the adjustment.
“STORED” appears in the main display.
The selected input level will be kept in memory until
you change it.
If “Level OVER!” appears in the main display
during play
The input level is too high. Select “LEVEL 2” if the current level
is “LEVEL 1.”
• If the current level is “LEVEL 2,” adjust the output level on the
external component.
• “Level OVER!” will not appear if the “REC REMAIN” time or
the clock is shown in the main display.
AAC 128
Selecting the External Component
1
Press TUNER/LINE repeatedly until “LINE*”
(external component) is selected.
The unit automatically turns on.
• Each time you press the button, the source changes as
follows:
2
Start playback on the external component.
• For operating the external equipment, see its supplied
manual.
To change the information shown in the main
display
Each time you press DISP/CHARA on the remote control,
the information in the main display changes as follows:
1 Currently selected source name for the external
component—LINE, TAPE, DBS, VCR, TV, or
GAME (see page 26)
2 Remaining recording time in the HDD, calculated
based on the current setting of the recording mode
3 Recording mode currently selected
The current input level (see the right column) appears
for a while.
* If you have changed the source name of the external
component, the currently selected source name will
appear (see page 26).
FM AM
LINE
(See page 18.)
Clock
2
3
1
EN24-26_NXHD10R[B]f.pm6 02.6.24, 9:01 AM 25