JVC CA-NXHD10R - Manual (Page 34)

– 29 –
About CD indicator
Basic CD Operations
While playing a CD, you can do the following operations.
To stop playback for a moment
Press CD 3/8.
To resume play, press CD 3/8 again.
To locate a particular point in a track during play
Press and hold ¢ or 4 during play.
•
¢ : Fast-forwards the tracks.
•
4 : Fast-reverses the tracks.
To go to another track
Press
¢ or 4 repeatedly.
•
¢ : Skips to the beginning of the next or succeeding
tracks.
•
4 : Goes back to the beginning of the current or
previous tracks.
Before starting play, you can continuously skip or go back
to any track by holding the button.
To go to another track directly using the number
buttons
Pressing the number button(s) on the remote control
allows you to start playing the track number you want.
Ex. For track number 5, press 5.
For track number 15, press +10, then 5.
For track number 20, press +10, then 10.
For track number 32, press +10, +10, +10, then 2.
Source is
“CD,” but no
CD is loaded
A CD is
loaded
During
playback
During
a pause
To change the information shown in the main display
Each time you press DISP/CHARA on the remote control,
the information in the main display changes as follows:
1 Current track number
2 Elapsed playing time
3 Remaining recording time in the HDD, calculated
based on the current setting of the recording mode
4 Recording mode currently selected
Programing the Playing Order of the Tracks
—Program Play
You can arrange the order in which the tracks play before
you start playing. You can program up to 32 tracks.
On the remote control ONLY:
1
Load a CD.
2
Press CD 3/8, then 7.
The source is changed to “CD.”
3
Press FM/PLAY MODE repeatedly until “CD
PROGRAM” appears in the main display.
The PROGRAM indicator lights up on the display.
• If a program has been stored in memory, it will be
called up.
CD CD CD CD
PROGRAM
indicator
Clock
1 2 3
4
PROGRAM
AAC 128
EN27-31_NXHD10R[B]f.pm6 02.6.24, 9:02 AM 29