JVC CA-NXHD10R - Manual (Page 53)

– 48 –
Clock
1 2 4
5 3
Continued
4
Press LIBRARY to select a library where you store the
recording just done.
• Each time you press
LIBRARY, the library changes—
“Library 1” to “Library 10.”
• If you do not select any library within one minute, the
library currently flashing in the main display is
automatically selected.
5
Press SET to finish the recording.
“ENTRY” flashes in the main display for a while.
To stop while recording, press 7.
The following message also appears in the main display. So
follow steps 4 and 5 above (press
LIBRARY repeatedly to
select a library, then press SET).
To record a single track during playback
Press REC START while the desired track on the CD is
played back (regardless of the play mode).
The playback of that CD track stops, and the same track
starts playing back from the beginning again. Then, the
recording starts (with the currently selected recording
mode).
When the playback of the current track is over, recording
also stops and the following message appears.
Follow steps 4 and 5 above (press LIBRARY repeatedly to
select a library, then press SET).
If a name has been assigned to the selected library
Its assigned name will be shown.
If “CD AUTO REC OFF PLEASE!” appears in the
main display
You cannot record a track using this method while CD Auto
Recording is being performed (see page 45).
To change the information shown in the main display
while recording
Each time you press DISP/CHARA on the remote control,
the information in the main display changes as follows:
1 Current track number of the CD played
2 Remaining play time of the current track
3 Remaining recording time in the HDD, calculated
based on the current setting of the recording mode
4 Album number and its track number recorded
5 Recording mode in use
If you cannot record a CD using high speed
recording (PCM x2 REC or PCM x4 REC)
This might have occurred due to the recording condition of the
disc. Using a slower speed recording than the current one in use
(PCM x1 or PCM x2) may solve this trouble.
If the recording is not done correctly, or a track is
skipped while it is being played
Use analog recording (see page 51).
Tracks of less than 3 seconds cannot be created (or
recorded) in the HDD
During the first 3 seconds of recording of each track, you cannot
stop recording.
* 1 Prior to this operation;
– If you have turned off and on the unit, or if you have
recorded another source—FM, AM (MW/LW), or external
component, “Library 1” will appear.
– If you have recorded CDs, the last recorded library will
appear.
* 1
* 1
EN42-51_NXHD10R[B]f.pm6 02.6.24, 9:06 AM 48