JVC A-UXP38V - Manual (Page 11)

– 8 –
English
Continued
To audio output
Audio equipment
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX jacks by using audio cords (not
supplied).
To connect audio equipment
Be sure that the plugs of the audio cords are colored: White
plugs and jacks are for left audio signals, and red ones for right
audio signals.
Connect an optical digital cord (not supplied) between the optical
digital input terminal on the other equipment and the OPTICAL
DIGITAL OUT terminal.
To connect a TV set
You can connect a TV with a video input jack: used as a monitor
for video CD playback.
Auxiliary Equipment
To video input
TV
OPTICAL
DIGITAL
OUT
Protective plug
Before connecting the other equipment,
remove the protective plug from the
terminal.
Audio equipment with
an optical digital input
To optical digital input
To connect audio equipment with an optical digital
input terminal (For Hong Kong only)
You can record CD sound onto the connected digital equipment.
Use a screwdriver to rotate the voltage selector so the voltage
number the voltage mark is pointing at is the same as the voltage
where you are plugging in the unit. (See the back cover page.)
DO NOT plug in before setting the voltage selector
on the rear of the unit and all connection procedures
are complete.
Now, you can plug the AC power cord.
IMPORTANT: Be sure to check all connections to be done
before plugging the AC power cord into a wall outlet.
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Voltage mark
EN01-11.UX-P38[US,UB,UN] 31/07/2001, 10:25 am 8