Playing back tapes – JVC A-UXP38V User Manual
Page 22
– 19 –
English
To stop playing, press
7.
To fast-wind to the left or to the right, press
¢ NEXT or
PREV
4 button.
The tape direction indicator (
3 or 2) starts flashing quickly on
the display.
To remove the cassette, press
0 button for cassette deck.
To play both sides — Reverse Mode
You can set the deck to play just one side of a tape,
both sides once, or both sides continuously.
Press REV.MODE on the unit.
• Each time you press the button, reverse mode
changes as follows:
:
The deck automatically stops after playing both
sides of the tape. (Stops when playback in the
2
direction is finished.)
:
The deck continues to play both sides of the tape
until
7 is pressed.
:
The deck automatically stops after playing one
side of the tape.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration may
occur and this tape easily jams in the pinch-rollers
and the capstans.
Playing Back Tapes
You can playback type I, type II, and type IV tapes without
changing any settings.
Playing Back a Tape
1
Press
0 button for cassette deck.
2
Put a cassette in with the exposed part of the
tape down.
3
Close the cassette holder gently.
4
Press TAPE
2
2
2
2
2 3
3
3
3
3.
The unit automatically turns on and the tape play
starts. The tape direction indicator (
3 or 2)
flashes slowly on the display.
• Each time you press the button, the tape
direction changes.
3
3
3
3
3 : plays the front side.
2
2
2
2
2 : plays the reverse side.
When the tape plays to the end, the deck automatically stops
if the reverse mode is set to
. (See “To play both sides
— Reverse Mode.”)
EN12-19.UX-P38[US,UB,UN]
31/07/2001, 10:25 am
19