JVC A-UXP38V - Manual (Page 15)

– 12 –
English
Playing Back CDs (CD/CD-R/CD-RW)
CORRECT INCORRECT
3
Press SELECT CD
3/8.
The disc tray automatically closes and the first
track of the CD starts playing.
Track number Elapsed playing time
• The CD automatically stops when the last track of the CD
has finished playing.
To stop playing, press
7.
Total track number Total playing time
To remove the disc, press CD
0 on the remote control (or 0
on the CD player section).
• If the CD cannot be read correctly (because it is scratched, for
example)
“00 0000” appears on the display.
• If no CD is inserted
“NO DISC” appears on the display.
During Reading period, sometimes noise is generated by CD
mechanism.
• If an unreadable CD-R or CD-RW is inserted
“BLANK CD” appears on the display.
DO NOT try to open or close the CD tray by hand as
it will be damaged.
Basic CD Operations
While playing a CD, you can perform the following operations.
To stop playing for a moment
Press SELECT CD
3/8.
While pausing, the elapsed playing time flashes
on the display.
To resume playing, press SELECT CD 3/8 again.
To go to another track
Press MULTI KEY > / MULTI KEY < or
NEXT
¢ / PREV 4 repeatedly before or
during playback.
• MULTI KEY > or NEXT
¢ :
Skips to the beginning of the next
or succeeding tracks.
• MULTI KEY < or PREV
4 :
Goes back to the beginning of the
current or previous tracks.
To locate a particular point in a track
During play, press and hold NEXT
¢ or PREV 4.
• NEXT
¢ : Fast-forwards the tracks.
• PREV
4 : Fast-reverses the tracks.
This unit has been designed to playback the following CDs:
• CD
• CD-R
• CD-RW
Continued use of irregular shape CDs (heart-shape,
octagonal, etc.) can damage the unit.
General Notes
In general, you will have the best performance by keeping your
CDs and the mechanism clean.
• Store CDs in their cases, and keep them in cabinets or on
shelves.
• Keep the unit’s disc tray closed when not in use.
When playing a CD-R or CD-RW
User-edited CD-Rs (CD-Recordable) and CD-RWs (CD-
ReWritable) can be played back only if they are already
“finalized”.
• You can playback your original CD-Rs or CD-RWs recorded
in music CD format. (However, they may not be played back
depending on their characteristics or recording conditions.)
• Before playing back CD-Rs or CD-RWs, read their
instructions or cautions carefully.
• Some CD-Rs or CD-RWs may not be played back on this
unit because of their disc characteristics, damage or stain on
them, or if the player’s lens is dirty.
• CD-RWs may require a longer readout time. (This is caused
by the fact that the reflectance of CD-RWs is lower than for
regular CDs.)
Playing Back the Entire CD — Normal Play
1
Press CD
0 on the remote control
(or
0 on the CD player section).
The unit automatically turns on and the disc
tray comes out.
2
Place a disc correctly on the circle of the disc
tray, with its label side up.
• When using a CD single (8 cm), place it on the inner circle
of the disc tray.
EN12-19.UX-P38[US,UB,UN] 31/07/2001, 10:25 am 12