Juniper Networks EX4200 - Manual (Page 66)

master boot record. See the documentation for your USB flash drive for
information on how your USB flash drive is formatted.
Related Topics ■ See Rear Panel of an EX2200 Switch for port location.
■ See Rear Panel of an EX3200 Switch on page 9 for port location.
■ See Rear Panel of an EX4200 Switch on page 11 for port location.
■ See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch for
port location.
■ See Routing Engine (RE) Module in an EX8216 Switch for port location.
■ Booting an EX Series Switch Using a Software Package Stored on a USB Flash
Drive
Network Port Connector Pinout Information for an EX3200 or EX4200 Switch
A network port on an EX3200 or EX4200 switch uses an RJ-45 connector to connect
to a device.
The port uses an autosensing RJ-45 connector to support a 10/100/1000Base-T
connection. Two LEDs on the port indicate link/activity on the port and the port
status. See “Network Port LEDs in EX3200 and EX4200 Switches” on page 20.
Table 15 on page 40 provides the pinout information for the RJ-45 connector. An
RJ-45 cable, with a connector attached, is supplied with the switch.
Table 15: Network Port Connector Pinout Information for an EX3200 or EX4200 Switch
Description Signal Pin
Transmit/receive data pair 1
Negative Vport (in PoE models)
TRP1+ 1
Transmit/receive data pair 1
Negative Vport (in PoE models)
TRP1- 2
Transmit/receive data pair 2
Positive Vport (in PoE models)
TRP2+ 3
Transmit/receive data pair 3 TRP3+ 4
Transmit/receive data pair 3 TRP3- 5
Transmit/receive data pair 2
Positive Vport (in PoE models)
TRP2- 6
Transmit/receive data pair 4 TRP4+ 7
40 ■ Network Port Connector Pinout Information for an EX3200 or EX4200 Switch
Complete Hardware Guide for EX3200 and EX4200 Ethernet Switches