JVC RX-730R - Manual (Page 10)

Page 5
English
AM (MW/LW) Antenna Connections
Turn the loop until you have the best reception.
Snap the tabs on the loop into the slots of the
base to assemble the AM (MW/LW) loop.
AM (MW/LW) Loop Antenna
If reception is poor, connect an outdoor single vinyl-
covered wire to the AM EXT terminal. (Keep the AM
(MW/LW) loop antenna connected.)
AM (MW/LW) Wire Antenna
Note:
Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could
cause poor reception.
FM Antenna
Extend the FM wire antenna horizontally.
If reception is poor, connect the outside
antenna.
Before attaching a 75-ohm coaxial cable
(the kind with a round wire going to the
outdoor FM antenna), disconnect the
supplied FM antenna.
Outside FM Antenna Wire
Connecting the FM and AM (MW/LW) Antennas
FM Antenna Connections
AM
EXT
AM
LOOP
ANTENNA
GND
FM 75
COAXIAL
AM
EXT AM
LOOP
ANTENNA
GND
FM 75
CO AXIAL
AM
EXT AM
LOOP
ANTENNA
GND
FM 75
CO AXIAL
B A
AM
LOOP
ANTENNA
AM
EXT
GND
FM 75
COAXIAL
2 3 1
Using the Supplied FM Antenna
The FM antenna provided can be connected to the FM
75-ohm COAXIAL terminal as temporary measure.
Using the Standard Type Connector (Not Supplied)
A standard type connector (IEC or DIN45325) should
be connected to the FM 75-ohm COAXIAL terminal. A
B
Note: Make sure the antenna conductors do not touch any
other terminals, connecting cords or power cord.
This could cause poor reception.
RX-730RBK(EF)0054-001A.En.01-28 97.7.25, 6:26 PM 5