Star Micronics LC-90 NX-1010 - Manual (Page 22)

16 User Setup Utility
❏
Execute the command that installs the User Setup Utility:
A:\>SETUP
↵
❏
Select the language you want to use. and then press Enter .
The above screen appears in the language that you selected in the previous
step.
❏
Input the drive and directory names where you want the User Setup Utility
stored. The following is the default directory name that creates a directory
named “star” on your hard disk (drive C:) to store the User Setup Utility.
C:\star
You can use the left and right arrows,
Delete and Back space when
making changes in the box that contains the drive and directory names. If
you require assistance while this screen is shown, press
F1 for help.
❏
After you specify drive and directory names, press Enter .
The User Setup Utility program is started up as soon as you press Enter , so
you can use the pull-down menus to make the setup changes you want.
Please select Language
= Help
Star LC-90 / NX-1010 Installation of User Setup Utility Version 1.0
English
Deutsch
Français
Italiano
= Enter = Scroll down = Scroll up F1
= Abort ESC
Directory:
= Help
Star LC-90 / NX-1010 Installation of User Setup Utility Version 1.0
The HDD installation uses xxxKB of hard disk.
= Enter F1
Please Select Drive and Directory for Installation
C:\star_
You may install this Printer Setup Utility onto a floppy disk if required,
please see the users manual of the help [F1] for details.
= Abort ESC