Star Micronics LC-90 NX-1010 - Manual (Page 30)

24 User Setup Utility
Using the Paper window
While in the User Setup Utility, select Paper from the menu bar.
The following describes the various settings that are available for each
parameter on this screen.
Page Length
❏
Specify the length of the paper you are using.
Line Spacing
❏
Select the line spacing you want to use.
Auto LF with CR
❏
Switch auto LF with CR on ( Enabled ) or off ( Disabled ).
When auto LF (line feed) with CR (carriage return) is disabled, the computer
must send both a line feed code and a carriage return code at the end of each line.
Most applications do this automatically. When auto LF with CR is enabled, the
printer automatically performs a line feed whenever it receives a carriage return
from the computer.
Note the following check points when trying to figure out which setting to use
here:
✓
If you find that your output is double-spaced when it should not be, change
this setting to
Disabled .
✓
If you find that lines are printing over each other, change this setting to
Enabled .
Exit Load Save General Font Paper Adjust. Port Help
Page-
Length (•) 11 inch
( ) 8 inch
Line-
Spacing (•) 1/6 Inch
( ) 1/8 Inch
Auto LF
with CR (•) Disabled
( ) Enabled
Top-
Margin (•) 1/6"
Paper-
Out (•) Enabled
( ) Disabled
Tear-
Off ( ) Enabled
(•) Disabled
Timeout
Printing (•) Enabled
( ) Disabled
= Scroll up
= Scroll down = Menu Select TAB
SPACE = Next Box
= Set Function
Current Data: Current Paper Setting
*
*
*
*
*
*
*