Samsung CLP-775 SERIES - Manual (Page 87)

Supplies and accessories_ 87
When installing accessories, the battery inside the machine is a
service component. Do not change it by yourself.
There is a risk of an explosion if battery is replaced by an incorrect
type. Dispose used batteries according to the instructions.
Activating the added accessories in printer
properties
After installing added accessories, you need to select it in the printer
properties of the printer driver in order to use it.
1. Install the driver. (See "Installing the driver locally" on page 23 or
"Installing wired network connected machine’s driver" on page 28.)
2. For Windows 2000, select Settings > Printers.
• For Windows XP/2003, select Printers and Faxes.
• For Windows 2008/Vista, select Control Panel > Hardware and
Sound > Printers.
• For Windows 7, select Control Panel > Hardware and Sound >
Devices and Printers.
• For Windows Server 2008 R2, select Control Panel > Hardware >
Devices and Printers.
3. For Windows 2000, XP, 2003, 2008 and Vista, double-click your
machine.
For Windows 7 and Windows Server 2008 R2, right click your printer
icon > context menus > See what’ s printing.
4. Select the your machine’s driver and right-click to open Properties.
5. In printer driver properties, select Device Options.
6. In printer driver properties, set the necessary options.
7. Click OK.
Upgrading a memory module
Your machine has a dual in-line memory module (DIMM). Use this memory
module slot to install additional memory. (See "Available accessories" on
page 83.)
Installing a memory module
1. Turn the machine off and unplug all cables from the machine.
2. Open the control board cover. Release the screw, then lift up the cover
slightly and pull the cover to the right.
3. Take out a new memory module from its plastic bag.
4. Holding the memory module by the edges, align the memory module on
the slot at about a 30-degree tilt. Make sure that the notches of the
module and the grooves on the slot fit each other.
The notches and grooves illustrated above may not match those
on an actual memory module and its slot.
5. Press the memory module into the slot with care until you hear a 'click'.
Do not press the memory module strongly or the module may be
damaged. If the module does not seem to fit into the slot properly,
carefully try the previous procedure again.
6. Replace the control board cover and fasten the cover with the screw.
7. Reconnect the power cord and machine cable. Turn on the machine.
Installing a wireless network interface card
The machine is equipped with a network interface which allows you to use
your printer on a network. You can also purchase a wireless network
interface card to enable the use of the printer in wireless network
environments.
The order information is provided for optional wireless network interface
card. (See "Available accessories" on page 83.)
Installing a wireless network interface card
1. Turn the machine off and unplug all cables from the machine.
2. Open the control board cover. Release the screw, then lift up the cover
slightly and pull the cover to the right.