SOYO Motherboard SY-6BA+ IV - Manual (Page 47)

Hardware Installation SY-6BA+ IV
43
3.3V
-12V
GND
PS-ON
GND
GND
GND
-5V
5V
5V
3.3V
3.3V
GND
5 V
GND
5 V
GND
PW-OK
5VSB
12V
ATX Power
This motherboard requires a power supply, that meets the ATX 2.03
specifications. Make sure the power supply can support at least 720mA on
the 5V Standby lead.
Please install the ATX power according to the following pin assignment:
Ø Pay special care to the directionality.
2-3.4 Jumper Setting
Step 1. 5V Stand-by indicator LED (LED 1)
This LED is lit whenever the 5V Standby voltage coming from the ATX
power supply is available. If you have connected your ATX power supply
to the motherboard, LED 1 should be lit.
Step 2. External Suspend Button (JP1)
Some cases come with a suspend button, insert the plug into JP1. In
addition to this button, the system can also enter the suspend mode
through your OS.
Note: Suspend mode only functions if your Power Management mode is APM.
Make sure that the BIOS setting for Power Management is APM. Windows 98
can be installed with ACPI Power Management (default is APM), in this case
suspend mode will not function either.