SOYO Motherboard SY-6BA+ IV - Manual (Page 55)

Hardware Installation SY-6BA+ IV
51
2. Set the JP8 and JP9 to short if you use a FSB 66MHz CPU
3. Press and hold down the <Insert> key while turning on the system
power. Keep holding down the <Insert> key until you see the message
of the CPU type and frequency shown on the screen.
4. Press the <Del> key during the system diagnostic checks to enter the
Award BIOS Setup program.
5. Select [SOYO COMBO SETUP] and move the cursor to the [CPU
Frequency] field to set the proper working frequency.
6. Select [Save & Exit SETUP] and press <Enter> to save the new
configuration to the CMOS memory, and continue the boot sequence.
Note: SOYO does not guarantee system stability if the user over
clocks the system. Any malfunctions due to over-clocking are not
covered by the warranty.
2-3.9 Power Off
There are two possible ways to turn off the system:
1. Use the Shutdown command in the Start Menu of Windows 95/98
to turn off your computer.
2. Press the mechanical power-button and hold down for over 4
seconds, to shutdown the computer. If you press the power-button for
less than 4 seconds, then your system will enter into Suspend Mode.
You are now ready to configure your system with the BIOS setup program.
Go to Chapter 3: BIOS SETUP