SOYO Motherboard SY-6BA+ IV - Manual (Page 99)

The ATA 66 Driver installation SY-6BA+ IV
95
13. Click on the "Finish" button.
14. Then the system will ask you to restart the system. If the settings
reported in step 12 are not what set on the host adapter, you must
adjust the settings by using the device manager in the System control
panel before restarting your computer.
15. The driver for ACPI function is useful only if hardware supports
ACPI function.
Uninstalling the Driver
You can use the device manager in the System control panel to remove the
driver.
Ø Installing the Windows NT 4.0 Drivers
When Windows NT is up, install the HPT366 device driver as follows:
1. Installing Device Driver
(1.) Open My Computer
(2.) Open Control Panel
(3.) Double click icon SCSI Adapters
(4.) Click Drivers
(5.) Click Add...
(6.) Click Have Disk...
(7.) Insert the SOYO-CD with the HPT366 Windows NT 4.0 device
driver into your CD-ROM drive, and type "D:\drivers\hp-
ta66\NT40[Enter]", then click OK. (for D type your CD-ROM
driver letter)
(8.) Select HPT366 Ultra DMA Controller, you will be asked to enter
the full path to the HPT366 Ultra DMA Controller files, type in
D:\drivers\hp-ata66\NT40 and then click Continue
(9.) When asked to restart your computer, click Yes
Your hard disk drive attached to the HPT366 host adapter must be
partitioned and formatted before you can access it. Please see Partitioning