Sony STR-DE1015G - Manual (Page 27)

27
Playback/Recording
To turn off the selected component
Click in the bottom left corner. To turn on the
component, follow steps 1 to 3.
To turn off all components
Press SYSTEM OFF (for USA and Canadian models) or ALL
OFF (for other models) on the remote control.
To mute the sound
Click . The icon changes to . “MUTING” appears
in the display on the front panel. To turn the sound back on,
click on the icon again.
• For USA and Canada : You can also mute the sound by
pressing MUTING on the remote control. “MUTING”
appears in the display on the front panel. Press again to
restore the sound.
To listen to digital program sources (STR-DE1015G)
Click SETUP in the main menu, then click INPUT
MODE.
Click the buttons next to each program source to select
the audio signals you desire:
• AUTO : gives priority to digital signals when there
are both digital and analog connections. If there are
no digital signals, analog is selected.
• ANALOG : selects the analog audio signals input to
the AUDIO IN (L and R) jacks.
• DIGITAL (OPTICAL) : selects the digital audio
signals input to the DIGITAL OPTICAL IN jack.
• AC-3 RF : selects the digital RF audio signals input to
the DIGITAL AC-3 RF IN jack (LD/DVD only).
To listen to decoded Dolby Digital (AC-3) program
sources (STR-DE815/D760Z)
Click FUNCTION, then click 5.1 INPUT.
The video signal from the LD/DVD VIDEO IN jack is
automatically paired with the audio signals from the 5.1
INPUT jacks. When set to this mode, the audio signals
bypass the receiver‘s sound fields. To customize the
sound of the 5.1 INPUT, use the controls on your Dolby
Digital (AC-3) decoder.
To listen to the analog audio signals input to the LD/
DVD AUDIO (L and R) jacks, select LD/DVD from the
FUNCTION menu.
You can play video and audio components at the
same time
Play a video component you want, then play audio
component. Make sure the AUTO PLAY function is set
to off (see page 44).
Notes
• Components of the same type (e.g., Sony LD player) will
be controlled simultaneously by the on-screen controls.
• If a component does not respond, it may be because IR
codes from the IR emitter are not fully reaching the
component. In this case, connect the extra IR repeater
(supplied) and position it facing the component (see
“Infrared (IR) Repeater Hookups” on page 7). If the IR
repeater is already connected, change the position of the
IR repeater or program source.
• When 5.1 INPUT is selected, sound fields cannot be
selected or edited (STR-DE815G and STR-D760Z only).
INPUT MODE SETTING
EXIT RETURN
LD/DVD AUTO
DAT/MD AUTO
CD AUTO