Sony STR-DE1015G - Manual (Page 56)

56
Front Panel Operations (Remote Short-cuts: USA and Canada only)
3
Use digital processing control buttons ( / ) to
select the parameter you want.
See “Surround (SUR) parameters” below for
details.
4
Use digital processing control buttons ( / ) to
adjust the level of the parameter.
Note
Certain menu items may not be available for adjustment
depending on the current settings and menu modes.
Unavailable items appear dimmed when shown in the
display.
Surround (SUR) parameters (STR-DE1015G)
p Surround sound parameters (See page 40 for
details)
Surround effect level (Digital Cinema Sound modes only)
Initial setting is : EFFECT [_______]
It lets you adjust the “presence” of the current digital cinema
sound surround effect.
• In the KARAOKE mode, use the effect level to adjust the
amount of vocal cancellation. Greater effect levels produce
greater reduction of the vocals.
Wall Type
Initial setting is : WALL S___1___H
It lets you adjust the “brightness” of the current digital
cinema sound surround effect.
Front to rear seat position
Initial setting is : SEAT F___1___R
It lets you adjust the atmosphere of the current digital
cinema sound surround effect.
Left to right seat position
Initial setting is : SEAT L___1___R
It lets you adjust the atmosphere of the current digital
cinema sound surround effect.
Reverberation time
Initial setting is : REVERB S___1___L
It lets you adjust the amount of reverberation present in the
current digital cinema sound surround effect.
Low Frequency Extension (LFE) mix level (DISCRETE only)
Initial setting is : LFE MIX 0dB
This parameter lets you attenuate the level of the LFE (Low
Frequency Extension) channel output from the sub woofer
without effecting the level of the bass frequencies sent to the
sub woofer from the front, center or rear channels via the
bass redirection circuitry.
4
Use digital processing control buttons ( / ) to
adjust the level, then press (
/ ) to select the
frequency (Hz). You can adjust the level ± 10 dB
in 0.5 dB steps.
5
Repeat steps 3 and 4 to make all necessary
adjustments.
To adjust the tone parameters
(STR-DE815G / D760Z)
For the on-screen operations, see page 39.
1
Start playing a component, then select the sound
field you want to adjust.
2
Press DPC MODE repeatedly until the TONE
indicator lights up.
3
Use digital processing control buttons ( / ) to
select BASS or TREBLE.
Bass adjustment
Initial setting is : 0 dB
Treble adjustment
Initial setting is : 0 dB
4
Use digital processing control buttons ( / ) to
adjust the tone level. You can adjust the level ± 10
dB in 2 dB steps.
5
Repeat steps 3 and 4 to make all necessary
adjustments.
To turn off the equalizer or tone adjustments
without erasing them
Press DIRECT PASS.
To adjust the surround sound parameters
For the on-screen operations, see pages 37 and 40 (STR-
DE1015G) or 38 and 40 (STR-DE815G / D760Z).
1
Start playing a component, then select the sound
field you want to adjust.
2
Press DPC MODE repeatedly until the SUR
indicator lights up.