Woodstock SHOP FOX W1824 - Manual (Page 21)

Df[\cN(/)+('?pYi`[KXYc\JXn
-19-
J<
K
L
G
14. Attach the fence rail tube to the front rail with (5)
M6-1 x 16 cap screws, 6mm flat washers, and 6mm
lock washers, as shown in Figure 20. Finger tighten
the fasteners for now.
15. While standing in front of the fence rail tube, pull it
toward you as far as possible, then fully tighten the
fasteners installed in Step 14. This will help make
sure there is enough room for the fence to slide.
16. Install the blade as instructed in the Blade
Installation procedure on Page 27.
17. Place the fence assembly onto the fence rail tube,
as shown in Figure 21.
18. Perform the Miter Slot to Blade Parallelism
procedure as instructed on Page 60.
19. Perform the Fence Adjustments procedure as
instructed on Page 65.
Figure 20. Fence rail tube attached.
x5
Figure 21. Fence assembly installed.
If the table or fence is not properly aligned with the
blade, the workpiece could bind during a cutting
operation, which could result in kickback injuries.
The miter slot and fence MUST be correctly aligned
with the blade before continuing to Step 20.
20. Move the fence over so that it just touches the
blade, and verify that the indicator line is directly
over the zero line.
— If you need to correct the position of the indicator
line, loosen the screws on the pointer window,
adjust it so that the line is over the zero line on
the scale (see Figure 22), then re-tighten the
screws.
21. Install the blade guard as instructed in the Blade
Guard Assembly procedure on Page 28.
Figure 22. Fence pointer window
alignment.
Pointer Window
Cap Screws
Indicator
Line