Woodstock SHOP FOX W1824 - Manual (Page 45)

Df[\cN(/)+('?pYi`[KXYc\JXn
-43-
FG
<
I
8
K@FEJ
The danger of kickback increases
relative to the depth of a cut. Reduce
the risk of kickback by making multiple
passes to achieve the desired depth of
cut. Failure to follow these warnings
could result in serious personal injury.
Always use push sticks or push paddles
to increase safety and control during
operations which require that the blade
guard and spreader must be removed
from the saw. ALWAYS replace the blade
guard after resawing is complete.
8. Plug in the table saw, turn it ON, and use a push
stick or push block to feed the workpiece through
the blade, using a slow and steady feed rate.
9. Flip the workpiece end for end, keeping the same
side against the fence, and run the workpiece
through the blade again.
10. If necessary to complete the operation, repeat Steps
7–9 until the blade is close to half of the height of
the board to be resawn. The ideal completed resaw
cut will leave an
1 ⁄
8
" connection when the resawing
is complete, as shown in Figure 62. Leaving an 1 ⁄
8
"
connection will reduce the risk of kickback.
11. Turn OFF the table saw, then separate the parts of
the workpiece and hand plane the remaining ridge to
remove it.
12. When finished resawing, remove the resaw barrier
and auxiliary fence, then re-install the blade guard/
spreader or riving knife and standard table insert.
8lo`c`Xip
=\eZ\
=\eZ\
I\jXn
9Xii`\i
( &
/
:fee\Zk`fe
Nfibg`\Z\
Figure 62. Completed resaw operation.