Woodstock SHOP FOX W1824 - Manual (Page 22)

Df[\cN(/)+('?pYi`[KXYc\JXn
-20-
J<
K
L
G
Recommended CFM at Dust Port: ................ 400 CFM
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the
dust port, you must take into account many variables,
including the CFM rating of the dust collector, the length
of hose between the dust collector and the machine,
the amount of branches or Y's, and the amount of other
open lines throughout the system. Due to the numerous
variables involved, we do not cover this calculation in
this manual. If you are unsure of your system, consult an
expert or purchase a good dust collection "how-to" book.
Dust Collection
DO NOT operate this machine without an adequate
dust collection system. This machine creates
substantial amounts of wood dust while operating.
Failure to use a dust collection system can result in
short and long-term respiratory illness.
22. Attach the switch to the bottom left-hand side of
the front rail using (2) M5-.8 x 12 cap screws, (2)
5mm lock washers, and (2) 5mm flat washers (see
Figure 23).
Figure 23. Switch installed.
x2
Tools Needed Qty
Dust Collection System ........................................1
Dust Hose 4" .....................................................1
Hose Clamps 4" ..................................................2
To connect a dust hose to the table saw, do these
steps:
1. Fit a 4" dust hose over the dust port, as shown in
Figure 24, and secure it tightly in place with a hose
clamp.
2. Tug the hose to make sure it does not come off.
Note: A tight fit is necessary for proper
performance.
Tip: To make the job of attaching the dust hose
easier, we recommend using the Model W1038 Quick
Disconnect (see Figure 25). This will be especially
helpful if the table saw is mounted on a mobile
base.
Figure 24. Dust hose secured to the table
saw.
Figure 25. Model W1038 Quick Disconnect.