Woodstock SHOP FOX W1824 - Manual (Page 66)

Df[\cN(/)+('?pYi`[KXYc\JXn
-64-
J<I
M
@:<
Adjusting Alignment
The spreader/riving knife mounting position can be
adjusted into alignment with the blade using the cap
screws on the spreader/riving knife "L" bracket.
Tools Needed Qty
Hex Wrench 5mm ...............................................1
Straightedge .....................................................1
To adjust the spreader/riving knife position, do these
steps:
1. DISCONNECT SAW FROM POWER!
2. Remove the table insert.
3. Loosen the two cap screws on the "L" bracket
(see Figure 102), then adjust the position of the
"L" bracket as necessary to correctly align the
spreader/riving knife with the blade and into the
"Alignment Zone".
4. Re-tighten the two cap screws on the "L" bracket to
secure the spreader/riving knife adjustment.
Adjusting Bent Spreader/Riving Knife
1. DISCONNECT SAW FROM POWER!
2. Remove the spreader/riving knife from the machine
to straighten it. Check it to make sure it sits evenly
on a flat surface.
— If you cannot straighten it properly, replace it.
Figure 102. Location of the L-bracket.
Cap
Screws
L Bracket