Sony UP20 - Manual (Page 11)

Pre
par
at
ion
Connections
11
Connecting the Video Monitor
Connect a video monitor to view captured images and to
check those to be printed. Connect a suitable video
monitor which will be used in actual printing, using the
following diagram as a guide.
Before connecting the video equipment, see “Important
safeguards/notices for use in the medical environments”
on page 2.
When connecting the video monitor only to the
RGB OUTPUT connectors (only for the UP-
21MD)
When connecting the video monitor only to the RGB
OUTPUT connector without connecting to SYNC
connector, set SYNC ON G in the OUTPUT SETUP
menu to ON.
to RGB input
connectors
to composite
video input
connector
75-ohm
coaxial cable
with BNC
connectors 75-ohm coaxial
cable with BNC
connectors
Connecting
cable (with
DIN 4-pin
connectors)
to RGB SYNC
OUTPUT
b)
to S VIDEO
OUTPUT
a) Set the NTSC/PAL selector to match your TV system. To
switch the TV system, turn the power off once, then change
the setting. If you change the setting with the power on, this
mode will not be switched.
b) See “When connecting the video monitor only to the RGB
OUTPUT connectors (only for the UP-21MD)”.
Video monitor
UP-21MD
to wall outlet
to AC IN
AC power cord
(supplied)
NTSC/PAL selector
a)
to VIDEO
INPUT
to S VIDEO
input
connector