Sony ZS-M30 - Manual (Page 31)

Editing recorded tracks on the MD
31 GB
Cursor
1
During recording, press EDIT
repeatedly until “Disc Name” or “Track
Name” appears in the display, and press
YES•ENTER.
When you label an MD, select “Disc
Name”.
When you label a track, select “Track
Name”.
2
When you label a track, turn the jog dial
to select a track number in a CD, and
press YES•ENTER.
When you label an MD, proceed to step
3.
3
Turn the jog dial clockwise or
counterclockwise to select the character,
and press
k to make the cursor shift
rightward.
You can also use the following buttons:
Button to use Function
DISPLAY Each time you press the
button, the character
changes as follows:
Uppercase letters
t
Lowercase letters t
Numbers and symbols.
K, k Move the cursor
leftward or rightward.
DEL Delete the character
marked by the cursor.
4
Repeat step 3 to complete an entire
name.
5
Press YES•ENTER.
The name has been labelled on the MD
or the track.
The characters you can input
• Uppercase letters: ABCD.....WXYZ
• Lowercase letters: abcd.....wxyz
• Numbers and symbols: 0123456789!"#$%&()*.;
<=>? @_`+ –’,/: (space)
Note
After you stop editing, do
not disconnect the mains
lead or move the player while “TOC EDIT”
is flashing in the display.
If you do so, editing
may not be done properly.
During REC IT recording
You can label a track only. You can input up
to 100 characters.
1
During recording, press EDIT.
The display waits for the input of the
characters.
2
According to steps 3 and 4 in
“Labelling during recording”, label a
track.
3
Press YES•ENTER.
The name is labelled on the track.
continued