Smeg WO-01 - Manual (Page 21)

- 47 -
In standby (system not running) :
Pressing F1 runs a water flushing cycle.
X.X indicates the software version (e.g. 2.1) Display:
After a few minutes, switch off and on again with the osmosis pump switch.
In stand by: hold down UP/DOWN together to enter programming mode:
(in all the following procedures: UP/DOWN changes the value, ENTER saves and continues, F1 continues
without saving).
Programming procedures: >>>>>>>>>>>>>>>>>>>>>>>>
X.X indicates the software version (e.g. 2.1) Display: Program filtration hours
Press ENTER or F1:
Flussaggio auto (auto flush):
This is an auto flush cycle run by the system to prevent
stagnation in the circuit. After the set number of hours, the
solenoid valves open to flush/refresh the water in the
circuit.