Sub-Zero Steamer Module - Manual (Page 11)

11
W O L F S T E A M E R M O D U L E U S E & C A R E
Dimensions in parentheses are in
millimeters unless otherwise specified.
T Y P E O F WAT E R
The type of water used in the steamer module
will determine how easy the clean up will be.
Refer to Care Recommendations on page 16
for additional information.
Hard water can leave calcium deposits in the
steamer basin and will need to be cleaned with
a vinegar and water mixture or another cleaner
especially designed to remove minerals. Let
mixtures stand in the basin, then scrub with a
nylon brush or dishcloth. Rinse well before
using.
Soft water can leave salt deposits in the
steamer basin and can be wiped out with a wet
cloth. Rinse well before using.
Distilled or reverse osmosis water will leave no
deposits in the steamer basin. Clean with
soapy water. Rinse well before using.
D R A I N S T R A I N E R
A screen drain strainer is installed into the
drain outlet to keep food particles from
clogging the drain valve. The strainer should
remain in the drain outlet during normal use
and cleaning. Lift the drain strainer out and
rinse after each use to remove food particles.
WAT E R L E V E L S A F E T Y F E A T U R E
W A T E R L O W I N S T E A M E R B A S I N
During extended use, water in the steamer
basin may boil off to a level that could damage
the unit. If this occurs, the unit will beep three
times, the light in the ”key” touch pad will
flash and the word “Lo” will appear in the
temperature display. Power to the heating
element will be automatically turned off and
the unit will enter Lock mode.
Add water to the steamer basin. Touch CLEAR
to reset the control and begin normal opera-
tion once the unit exits Lock mode.
IMPORTANT NOTE: If the unit has entered
into this safety feature, it may require a few
minutes for the electronic sensors to stabilize
after water has been added.
N O W A T E R I N S T E A M E R B A S I N
If there is no water in the steamer basin and
the steamer module is turned on, the unit will
beep three times, the light in the ”key” touch
pad will flash and the word “Lo” will appear in
the temperature display. Power to the heating
element will be automatically turned off and
the unit will enter Lock mode.
Add water to the steamer basin. Touch CLEAR
to reset the control and begin normal opera-
tion once the unit exits Lock mode.
IMPORTANT NOTE: If the unit has entered
into this safety feature, it may require a few
minutes for the electronic sensors to stabilize
after water has been added.