Samsung SNS-100/400 - Manual (Page 28)

SNS-100/400 Network Server
26
◊ RS485/422 Setup
Item Description
Baud Rate Set the data transmission speed per second
Data Bit Set the data transmission bit
Parity Bit Select error-check method when data is displayed
Stop Bit Set insert bit when data transmission is completed
Note
When RS-485/422 setup configuration is incorrect, the PTZ camera motion may not work. See the users’
manual for the connected camera and carefully configure it accordingly.
◊ Swing Setup
Item Description
First Preset / Second Preset Designate the two presets to be used in swing mode
Mode Select movement method between the two points((Pan/Tilt Swing)
Speed Set movement speed
Duration Sets the stop time at one preset point
◊ Group Setup
Item Description
Group No. Sets the desired group number
Preset No. Sets each point’s preset number
Travel Speed Sets the travel speed between each point interval
Dwell Time Sets the stop time at each position
4.2.7. Motion Detection
This sets up motion detection function of the network server.
◊ Motion Detection Configuration
Item Description
Channel Set Used when selecting the channel. (Applied only to 4 channel servers.)
Grid Display Basic grid, used to choose area on the screen, is displayed or hidden.
Select Area
When selecting motion detection area, click <Select All> button to select all areas, or click <Deselect> button
to cancel the selected area.
MD Enable Decide whether you use motion detection function.
MD Sensitivity
Setting up sensitivity to detect motion to adjust input video by situation. You can select 1-5, and 5 is the
highest.