Sony HDW-D2000 - Manual (Page 121)

Chapter 10
Setup Menus
10-24
Chapter 10 Setup Menus
10-4 Items in the Extended Setup Menu
Item number Item name Settings
Menu items in the range 700 to 799, relating to video control (Continued)
710 INTERNAL VIDEO
SIGNAL GENERATOR Select the test signal to be output from the VTR’s internal test signal generator.
OFF: No test signal is generated. (The VTR operates normally.)
CB : Color bar signal
MLTBS: Multi-burst signal
10STP: 10-step signal
PLSBR: Pulse and bar signal
RAMP: Ramp signal
BLACK: Black signal
To turn on the internal test signal generator, hold the F1 (VID.IN) button in
function menu HOME page for three seconds or more with this menu item set to
other than OFF. When the test signal generator is turned on, the display of the
VID.IN setting changes to SG. To turn off the test signal generator, press the F1
(VID.IN) button in function menu HOME page again.
712 VIDEO PROCESS ON
CAP LOCK 2FIELD
(Invalid in 24PsF or
23.98PsF mode) When the function menu item CAPSTN or setup menu item 106 is set to 2F for 2-
field playback, select whether or not to carry out a “picture shift”.
OFF : No picture shift
ON: Carry out picture shift.
Note
To eliminate the adverse effect of the residual chrominance subcarrier component
in the Y signal that is the result of the Y/C separation, this unit automatically
applies a shift to the playback image in the H direction, so that even in 2-field
playback a satisfactory image can be obtained.
713 VIDEO SETUP
REFERENCE LEVEL
(Valid only in 59.94i or
29.97PsF mode) Set the video setup amount to be added to the composite output signal.
Note
The setup amount specified in this menu item has no connection with the setting
of F5 (SETUP/BLACK) in function menu page 2.
Sub-Item
0 When the output signal setting is “MSTER” (master), the setup amount specified
for this sub-item is added to the signal.
0.0% to 7.5% to 10.0%: Setting in this range, in 0.5% increments. MASTER
LEVEL
MSTER : Set the output signal to the master setting.
0.0% to 7.5% to 10.0%: Set the setup amount to be added to the output signal in
this range, in 0.5% increments.
2 OUTPUT LEVEL
In 525/59.94
(SY) mode
In 525/59.94
(J) mode When the output signal setting is “MSTER” (master), the setup amount specified
for this sub-item is added to the signal.
0.0% to 7.5% to 10.0%: Setting in this range, in 0.5% increments.
(Continued)