Sterilite Point-of-Use Drinking Water System - Manual (Page 4)

4
OUTLET
OUTLET
OUTLET
INLET
INLET
INSTALLATION
Shipped with the faucet diverter, your Sterilight
unit is ready for installation on most kitchen
faucet heads.
A. STAND MOUNTING:
Find a suitable location for your unit, and simply
place it with the stand provided. Excess hose
and/or power cord may be wrapped inside the
unit’s stand (Figure 2).
Figure 2
Counter-top stand mounting
B. WALL MOUNTING
1. To wall mount the
unit, you must first
remove the
counter-top stand.
This stand is
secured to the unit
with two
semi-permanent
adhesive pads.
They can be pried
loose by pulling
firmly down on the
back of the stand
or by using a
screwdriver or
lever to pry the
stand from the
bottom of the unit
(Figure 3). Once
the stand is
removed, the
adhesive pads can
be peeled off from
the stand and/or
bottom of the unit
Figure 3
Counter-top stand removal
Figure 4
Adhesive pad removal
(Figure 4).
The adhesive pads are not required for the stand to function.
The Diverter valve hoses attach (Figure 5), with the hose to the top of
the diverter attaching to the inlet elbow, and the hose to the bottom of
the diverter attaching to the outlet tube.
Figure 5
Diverter valve hose routing