Sterilite Point-of-Use Drinking Water System - Manual (Page 9)

9
glass sleeve in the unit. Ensure that the glass sleeve is wet,
and guide the filter over the sleeve (Figure 20).
Be sure to guide the outlet tube into the bottom fitting.
14. Tighten the cap and reconnect all fittings. Reconnect power.
15. Run water through the unit for 5 minutes to flush the filter
before use.
IMPORTANT! Use only filters supplied by your Sterilight dealer.
Approved filters are specifically matched to your unit. Using the wrong
filter will negatively effect unit operation, will void the unit warranty,
and can adversely affect the safety of water leaving the unit.
REPLACING THE UV LAMP
The Sterilight unit uses a high-intensity ozone generating lamp which
can be obtained from your Sterilight dealer. For proper unit operation,
use only lamps supplied by your Sterilight dealer. The lamp should be
replaced whenever it fails to light during operation.
cap. Push it firmly
into the
cap until it is
completely seated
(Figure 18). The
filter should stay
firmly in the to cap.
12. Ensure that the
lower filter O-ring
seal is in place
(Figure 19).
13. The lower seal
slides over the
Figure 17
Wet glass sleeve
Figure 18
Installing the filter into the cap
Figure 19
Checking lower O-ring seal
Figure 20
Installing the filter in the unit