Southwestern Bell FM2560 - Manual (Page 5)

Installation
CAUTION:
1. Never install telephone wiring during a lightning storm.
2. Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
3. Never touch uninsulated telephone wires or terminals unless
the telephone line has been disconnected at the network
interface.
4. Use caution when installing or modifying telephone lines.
Note: Refer to the "FCC Requirements" section on page 26 before
connection to telephone line.
To Install Batteries
a. Open the battery door with a ball-point pen.
Remarks:
If no battery is installed, the caller ID
function of the phone will not work.
b. Insert three AA alkaline batteries, making sure to observe the
correct battery polarity.
c. Replace the battery door.
Note: After installing the batteries, the system will display
"SET LANGUAGE s
t". Your FM2560 enters setting mode. (See
setting up your FM2560 section for details).
9
General Information
UNPACKING
This package contains:
• FM2560 Telephone with Call Waiting Caller ID
• Owner's Manual
• One (1) Fully Modular Coil Cord
• One (1) Fully Modular Telephone Line Cord (Long Straight Cord)
• One (1) Fully Modular Telephone Line Cord (Short Straight Cord)
• One (1) Quick Installation Guide
• Warranty Card (Part of Owner's Manual)
If anything is missing or damaged, contact the place of purchase.
Keep the packaging to transport the telephone.
Helpful Tips From Customer Service
1. You must subscribe to Caller ID and Call Waiting service from your
local telephone company for your FM2560 to operate.
2. Remove the clear Caller ID label covering the FM2560's display.
3. Plug one end of the telephone line cord into the TELEPHONE
LINE jack on the FM2560 and the other end into the modular outlet in
your telephone wall jack.
4. Make sure you can read the display clearly. Adjust the display
contrast by pressing and holding the REDIAL and REVIEW
s
buttons (in the location on the button labeled at the same time for 2
seconds. Press the REVIEW button to select the contrast level. Press
ERASE button to confirm the contrast. •)
8