Southwestern Bell FM2560 - Manual (Page 7)

Telephone Operation
Dialing a Call
1. Lift the HANDSET.
2. When you hear a dial tone,
dial the number. LCD Display
Shows:
3. At the end of the call, return
the HANDSET to the
CRADLE.
4. When the unit is in the standby mode (i.e. not displaying Caller ID
information), the current time will display in the middle of the screen.
In the situations when the Caller ID information is displayed, the
current time will be shown in a smaller size on the top line.
12 13
flash
flash
Month Day
AM
NEW
CALL AM
Receiving a Call
1. When you hear your phone
ring, lift the HANDSET. After
the first ring, if you have Caller
ID service, the NEW CALL
icon and call information will
appear on the display, and the
NEW CALL LED will flash.
The caller ID information will be stored in the order received.
2. At the end of your call, return the HANDSET to the CRADLE .
NOTE: 1. If you answer your telephone before the second ring, the
unit will not display any Caller ID information.
2. The information will be displayed on the LCD for 20 seconds. If
the received call information is the same as any of the new calls, the
unit displays "RPT" icon to indicate a REPEAT CALL.
3. The maximun number of digits that can be displayed on the LCD is
10 and the maximum call count is 64 (old calls + new calls). Your
FM2560 will automatically erase the oldest call record and replace it
with the newest call record when the memory is full.
NEW
CALL AM
Setting Up Your FM2560
2. Press ERASE Button to
confirm selection. The unit will
then proceed to the area code
setting mode.
To Set Area Code
Note: In order for the Caller
ID Redial feature to work properly, you must set your area code.
1. Press the REVIEW
s or t Button until you have entered the
correct first digit of your
local area code. Press the Erase
Button to move to the next digit.
2. Repeat step 1 for the progra-
mming of the second and third
digits of your local area code.
3. Press the ERASE Button
again to end the setting. The
display will show the default
time and day. The unit is now
ready to receive calls.
The correct date and time are
automatically set when your
FM2560 receives its first call.
Note: 1. If you try to use the telephone before finishing the Caller ID
set up, or if you pause more than 40 seconds during any of the above
steps, the display will show "SET LANGUAGE" to remind you to
finish this sequence.
2. To set up your FM2560 again, press and hold the REDIAL Button
for 2 seconds to restart setup.
3. If you only want to adjust the LCD display contrast in standby
mode or in review mode, press and hold the REDIAL and REVIEW
Buttons (in the location on the button labeled at the same time.
LCD will show "CONTRAST s t", to indicate that your FM2560
has entered contrast setting mode.
s •)