Southwestern Bell FM2560 - Manual (Page 6)

10
Installation
Replace the batteries when the
Battery Low Indicator
appears on the LCD display.
USING THE PHONE ON A DESK
a. Plug the long telephone line cord into the jack in the bottom of
the BASE. Thread it through the groove toward the back of the
unit, and then plug it into the modular wall jack.
b. Connect the COIL CORD to the jack in the HANDSET and the
BASE.
AM
HANGING THE PHONE ON THE WALL
When the FM2560 is wall-mounted, the HANDSET GUIDE
holds the HANDSET in place in the CRADLE.
ON A WALL PHONE PLATE:
a. Plug the short telephone line cord into
the jack in the Base bottom and into the
jack on the plate.
b. Hang the BASE on the two pins and
push the BASE down to lock it on.
c. Plug the COIL CORD into the
HANDSET and BASE jacks.
ON THE WALL WITHOUT A PLATE:
a. Install 2 screws with anchors into the
wall, one above the other, 3-1/4" apart,
extending 3/16" out from the wall, to
hold the base securely.
Installation
b. Install the long telephone line cord into
the jack in the BASE. Thread it through
the groove, and plug it into the modular
wall jack as shown.
c. Hang the base on the screws and pull it
down to lock it on.
d. Plug the COIL CORD into the
HANDSET and BASE jacks.
11
Setting Up Your FM2560
NOTE: Do not lift the handset until you are finished setting the
Caller ID information.
To Set Language
1. If "SET LANGUAGE" is not
already displayed on the screen,
press and hold the REDIAL
Button (on the back of the
handset) for 2 seconds. The
LCD display will then show
"SET LANGUAGE
".
2. Press the REVIEW s or t
Button to select English,
French or Spanish.
3. Press the ERASE Button
to confirm the language selected.
The unit will then proceed to
the contrast setting mode.
To Set LCD Display Contrast
1. Press the REVIEW s button to make the contrast darker or the
REVIEW
t button to make the contrast lighter.
s t