Sony DSR-70 - Manual (Page 25)

Chapter 1
Overview
Chapter 1 Overview
25
3 AUDIO INPUT CH-1/CH-2 connectors (XLR 3-
pin, female)
Input the analog audio signals of input channels 1 and
2.
4 AUDIO OUTPUT CH-1/3 and CH-2/4
connectors (XLR 3-pin, male)
Output the audio signals of the channels selected with
the LINE OUT in the sub LCD menu. You can select
two combinations of output signals: channels 1 and 2,
or channels 3 and 4.
For more information about LINE OUT settings, see page
71.
Note
The level can be adjusted from the control panel, but
mixed signals cannot be output.
5 REF. VIDEO IN/OUT (reference video signal
input/output) connectors (BNC type) and 75
Ω
termination switch
When using an external reference video signal, input it
to one of the REF. VIDEO IN connectors. Set the 75
Ω
termination switch to OFF when the signal is bridged,
and to ON when the signal is not bridged.
The REF. VIDEO OUT connector outputs a reference
video signal.
6 VIDEO INPUT (analog composite video input)
connectors (BNC type) and 75
Ω
termination switch
Input an analog composite video signal. Set the 75
Ω
termination switch to OFF when the signal is bridged,
and to ON when the signal is not bridged.
7 VIDEO OUTPUT (analog composite video
output) 1 and 2 (SUPER) connectors (BNC type)
Output analog composite video signals. When the
CHARACTER switch is set to ON, timecode, menu
settings, error messages and other information is
superimposed on the output of 2 (SUPER) connector.
For details about the superimposed information, see page
61.
8 S VIDEO IN/OUT connectors (4-pin)
Input an S-video signal with separated Y (luminance)
and C (chroma: 3.58 MHz for DSR-70 and 4.43 MHz
for DSR-70P) components to the S VIDEO IN
connector.
The S VIDEO OUT connector outputs an S-video
signal.
9 MONITOR AUDIO connector (phono jack)
Output the audio signals of the channels selected with
the MONITOR in the sub LCD menu. The level is
adjustable, and mixing is possible.
For more information about the MONITOR item, see page
71.