Sony DSR-70 - Manual (Page 72)

72
Chapter 4 Time Data and Sub LCD Menu
Chapter 4
Time Data and Sub LCD Menu
Input and Output Settings for Video and Audio Signals –– Sub LCD Menu
Input mixing settings page
By pressing F1 to F3, you can make the following
three settings for mixing of input signals in audio
channels 1 and 2. The selected setting is highlighted.
To select input signals, use audio settings page 1-2.
MIX OFF: Assign IN-1 to channel 1, and assign IN-
2 to channel 2.
1+2
→
1: Assign mixed signals of IN-1 and IN-2 to
channel 1, and assign IN-2 to channel 2.
1+2
→
2: Assign IN-1 to channel 1, and assign mixed
signals of IN-1 and IN-2 to channel 2.
Output monitor settings page
By pressing F1 to F3, you can make the following
three settings for monitor output signals. The selected
setting is highlighted.
1: Assign channel 1 to monitor output.
2: Assign channel 2 to monitor output.
1+2: Assign mixed signals from channels 1 and 2 to
monitor output. (This corresponds to the
MONITOR item setting “METER” in audio
settings page 1-3.)
Making Settings in the Video
Settings Pages
The following tables show the items that can be set in
the video settings pages.
Video settings page
PP SIZE
1/9
ZEBRA
OFF
MONITOR
OUTPUT
PROCESS
CONTROL
PANEL
PP MODE
OFF
WIDE
AUTO
PP POSI.
4
Item Setting
When composite video (CMPST) has been
selected for input, select the E-E signal for
output to the LCD monitor of the unit.
INPUT: Input video E-E with no digital
process delay is output.
OUTPUT: Output video E-E with a digital
process delay is output
Select how to display two input pictures on
the LCD monitor.
OFF: Not displaying two pictures.
1: Picture-in-picture display
2: Two pictures reduced and displayed side
by side
3: Side-by-side display reduced in horizontal
direction only
Select the size of the smaller picture to be
inset for picture-in-picture display on the LCD
monitor.
1/16:
1 /
16
the normal size
1/9: 1 /
9
the normal size
1/4: 1 /
4
the normal size
Select the position of the smaller picture to
be inset for picture-in picture display on the
LCD monitor.
1: Upper left position
2: Upper right position
3: Lower left position
4: Lower right position
Select what to use to control the following
items: SETUP (when using the setup menu)
or PANEL (when using the front control
section).
• Video output level
• Chroma signal output level
• Setup level (DSR-70)/black level (DSR-
70P)
• Chroma phase
Select whether to record/play back video with
wide-screen aspect ratio information
requiring the LCD monitor to switch to 16:9
mode.
AUTO: The LCD monitor automatically
switches to 16:9 mode when wide screen
video is input or played back.
ON: The LCD monitor is always in 16:9
mode.
OFF: The LCD monitor does not switch to
16:9 mode.
Set the zebra pattern to be displayed in the
LCD monitor.
OFF: Do not display.
50%: Display zebra pattern with 50% or more
video level.
80%: Display zebra pattern with 80% or more
video level.
100%: Display zebra pattern with 100% or
more video level.
a) Displayed only when the DSBK-180/180P Dual Video Input
Board is installed
MONITOR a)
PP
MODE
a)
PP SIZE a)
PP POSI. a)
PROCESS
CONTROL
WIDE
ZEBRA