Sony DSR-70 - Manual (Page 83)

Chapter 5
Special Editing and Recording/Playback
Chapter 5 Special Editing and Recording/Playback
83
4
While watching the LCD monitor display, when
you wish to switch the display, hold down the +/
MARK button and press the –/LIST button.
The display on the LCD monitor as well as the
picture being recorded is switched.
5
To stop recording, press the STOP button.
Recording stops.
To adjust the output video signal phases
When long cables are used to connect two cameras to
this unit, a slight shift in phase between the video
signals input from the two cameras may result. When
the phase shift is of a significant magnitude, you can
detect it as a picture discontinuity on the LCD monitor
at the switch between the signals from the two
cameras.
To align the phases of the video signals from the two
cameras, adjust the phase of the output video signal
from one of the two cameras as follows.
LCD monitor
1
Holding down the ENTRY/SHIFT button, press
the MENU button.
The SYSTEM MENU screen appears on the LCD
monitor.
2
Using the jog/shuttle dial, select the VIDEO
PHASE CHECK item on the SYSTEM MENU
screen, then press the SET button.
The pictures from the two cameras are alternately
displayed on the LCD monitor (switched 30 times
per second (DSR-70)/24 times per second (DSR-
70P)).
3
If the text displayed on the LCD monitor jitters,
adjust the H PHASE (horizontal phase) of one of
the two cameras until the text stops jittering.
(Luminance signal phase adjustment)
(Continued)
1,5
2
2
1
OFF
ON
ON
OFF
LOCAL
REC INHI
REMOTE
INT
EXT
MENU
TC CHARACTER
SET
AUDIO IN
VIDEO
CH1,1/2 CH2,3/4
AUDIO
TRIM
LIST MARK CLIP
LINK
ENTRY SHIFT
IN OUT
ASSEMBLE INSERT
TC
– +
DELETE
SYSTEM MENU
VIDEO PHASE CHECK