Sony DSR-70 - Manual (Page 115)

Chapter 8
Connections and Settings
Chapter 8 Connections and Settings
115
Connections for Cut Editing Using SDI Interface
(Optional DSBK-160 Required)
For a cut editing system using this unit together with a
DNW-A25/A25P Betacam SX VCR using an SDI
connection, the following figure shows an example of
the connections. In this example, the DNW-A25/A25P
is used as the recorder and this unit is used as the
player.
Settings on the DNW-A25/A25P
DNW-A25/A25P (recorder)
REF. VIDEO IN REF. VIDEO OUT
SDI IN SDI OUT
REMOTE
REMOTE
Note
In this case, the DSBK-160 SDI Iuput/Output Board is
required.
1 75
Ω
coaxial cable (not supplied)
2 RCC-5G/10G/30G 9-pin remote control
cable (length 5 m (16 ft)/10 m (33 ft)/30
m (98 ft), not supplied)
DSR-70/70P (player)
1
2
1
Settings Required When Connecting an External
Editing Control Unit
When connecting an external editing control unit to
this unit and using this unit as a recorder, make the
following timecode settings on this unit and VCR
constant and DIP switch settings on the editing control
unit.
Switch/sub LCD menu
Timecode Settings on This Unit
Make the following timecode settings for this unit.
Setting
TC INT/EXT switch INT
Sub LCD menu
PRESET/REGEN item
(General settings page (1)) PRESET
Sub LCD menu
F-RUN/R-RUN item
(General settings page (1)) F-RUN
(These cables are included in the optional BKNW-225 Docking Kit.)
Settings on the DSR-70/70P
Switch Setting
REMOTE/LOCAL REMOTE
Switch/menu Setting
REF. VIDEO IN 75
Ω
termination switch
REMOTE/LOCAL LOCAL
OFF