Sony DSR-70 - Manual (Page 38)

Settings for Editing
Chapter 3
Editing
38
Chapter 3 Editing
Settings for Editing
When using two units of the DSR-70/70P as a pair of recorder and player
in an editing system, set the recorder and player as follows. Basically, the
same recorder settings and player settings apply when you use a DSR 70/
70P unit as a stand-alone recorder or player.
Recorder Settings
Make settings as follows.
1
Set the REMOTE/LOCAL switch to LOCAL.
2
Set the POWER switch to ON, then make the following checks.
When the unit is powered, the POWER indicator lights and the sub
LCD home page appears in the sub LCD.
3
7
4
2
5
6
1
LOCAL
REMOTE
INT
EXT
TC
POWER indicator
Sub LCD
UP/DOWN buttons
Check Indication/What to do See for details
Enough
battery
power
remaining? Check the remaining battery power indication.
If “BATT” is flashing
Replace the battery.
“ 5 Remaining
battery power
indication” (page
67)
If “HUMID!” is displayed
Leaving the unit powered, wait until the message
disappears.
(In this case, the alarm message “MOISTURE
HAS BEEN DETECTED” also appears on the
LCD monitor.) No
condensation
in the unit? “Condensation”
(page 127)