Suburban Mfg OXYGEN THERAPY DOOR 12155-00-DRDRAA User Manual
Page 28
24
SSCI - Suburban Surgical Company, Inc.
Chapter 4 - Repairs and Replacements
6.
Loosen the gauge bracket nuts and remove the gauge from
the door.
7.
With a 1/16 in. bit, drill two holes in the door at the
locations marked in Step 5 (Figure 26). This will provide
easy access to the buttons on the front of the gauge.
8.
Smooth out the outside and inside edges of the holes to
eliminate any rough edges.
9.
Remove the tape marked “REMOVE TO START” from
the battery compartment. When the tape is removed, the
gauge will begin operating.
10.
Position the Centigrade/Fahrenheit (°C / ° F) slide switch to
display the preferred units (Refer to Page 13).
11.
Place the gauge into the gauge bracket, again making sure
the gauge is right-side-up.
12.
Tighten the screws and nuts to secure the gauge.
Figure 26. Drilling Button Access Holes
Drill Holes Here