Sony DHR-1000 - Manual (Page 73)

Editing 73
You can replace the original picture with a scene from the source tape,
while retaining the original sound.
Before you start editing, set up the system according to the instructions
on pages 64 to 66.
For video insert editing, use the tape recorded by this VCR. If you want
to edit the one recorded by other VCRs (include other DHR-1000s), first,
you have to dub it to the tape on this VCR, then edit it. If you edit the
tape recorded by the other VCRs, the sound quality may be reduced
and the picture may be noisy.
1
Press COUNTER SELECT so that the
tape counter appears.
2
Locate the end point (A) of the
scene to be recorded over.
1 Press RECORDER.
2 Press ( (PLAY), then locate the
recording end point with the jog dial
or shuttle ring.
3 Press COUNTER RESET.
Editing with LANC cable
Video insert editing
(continued)
Notes
• Do not change the counter
display during insert
editing. Editing may not
function accurately.
• Insert editing cannot be
made on a blank portion of
the tape. When a blank is
detected, the VCR stops
editing.
• If you record on the
beginning part of the tape,
or on the part just after the
unrecorded portion, the
first part of recording may
be dropped.
COUNTER
RESET
RECORDER
Shuttle ring/
Jog dial COUNTER
SELECT
VIDEO INSERT
PLAYER
START/PAUSE
EDIT STANDBY
C
Replaced video section
B A
Edited tape
Source tape
p (STOP)
( (PLAY)